(Destination) in (Inbound Routes) is not displayed when created or edited

Create or edit an Inbound Route, then check that entry. The previously set destination is not displayed.

This started once I upgraded to 2.2.0rc2.
Inbound Routes set before the upgrade seem to display (and function) correctly.

Steps to repeat the issue:

A) Create an Inbound Route
1. click on Inbound Routes
2. enter data to create a new Incoming Route, including setting a destination (Many of my Incoming Routes I set to a Ring Group)
3. Click on SUBMIT
4. Click on APPLY CONFIGURATION CHANGES (Click on OK to apply)

B) Verify the Inbound Route
1. From the Inbound Route on the right, select the above entry that was just created
2. Look at the displayed value for (Set Destination)... No Destination is selected.

I do not know if this is simply a display issue (the Destination is actually set, but not displayed) or if the destination is not set at all.